- fil27tUtente attivo
- Numero di messaggi : 446
Data d'iscrizione : 15.05.14
Profilo giocatore
Località:
Livello:
Racchetta: steel colander pro
tensionamento ultime orizzontali e verticali nel JayCee
non capisco una cosa: R8 devo tensionarla singolarmente oppure tirarla insieme a R7 (idem per L8 e L7)?
Lo chiedo perchè da alcune parti è riportato di tirare insieme le 7 e 8 e da altre no.
Stesso discorso per le orizzontali, l'ultima e prima vanno tensionate o si tensionano insieme a seconda e penultima?
- jasperVeterano
- Numero di messaggi : 4142
Età : 49
Località : Liguria
Data d'iscrizione : 21.02.10
Profilo giocatore
Località: Genova
Livello: ITR 4.5 - Arrotino monomane
Racchetta: Babolat PD 2003
Re: tensionamento ultime orizzontali e verticali nel JayCee
- jasperVeterano
- Numero di messaggi : 4142
Età : 49
Località : Liguria
Data d'iscrizione : 21.02.10
Profilo giocatore
Località: Genova
Livello: ITR 4.5 - Arrotino monomane
Racchetta: Babolat PD 2003
Re: tensionamento ultime orizzontali e verticali nel JayCee
- fil27tUtente attivo
- Numero di messaggi : 446
Data d'iscrizione : 15.05.14
Profilo giocatore
Località:
Livello:
Racchetta: steel colander pro
Re: tensionamento ultime orizzontali e verticali nel JayCee
jasper ha scritto:Due corde assieme? Chi lo fa è un cane!
è quello che pensavo pure io finchè non l'ho trovato proprio descritto così (!!!)
A questo punto non vorrei che ci fosse una confusione linguistica, guarda la parte di sotto evidenziata in rosso.
Tu dici che le ultime corde (penultime sul piatto) andrebbero trazionate con cura 2 volte, mentre per come l'ho trovata scritta io per "double pull" penso che intenda il trazionamento simultaneo dell'ultima e della penultima (che sono contigue) e quindi è un tensionamento doppio.
Cioè non capisco una cosa, tu facendo un jaycee la R8 e la L8 le tensioneresti singolarmente oppure le tireresti tensionando R7 e L8?
[Devi essere iscritto e connesso per vedere questo link]
MAIN STRINGS: (16 main detailed)
1. String first three mains on each side at reference tension. (R1 – R3 & L1 – L3)|
2. Next 3 mains reduce tension by 4 pounds. (R4 – R6 & L4 – L6)
3. On a 16 main pattern after clamping off main #6 skip over to #8. Do NOT pull tension. Fill in #7. Increase tension to reference plus 4 pounds. You will then pull tension on #7 which will tension both #7 and #8 simultaneously. (Yes, this is a double pull.) While under tension strum #6, #7, #8 with your finger. The tonal response should get higher with each string as you progress to the frame. You will likely find #8 is a lower tone than #7. Push down firmly in the middle of #7 to raise the tension on #8. Clamp off.
4. Tie off on hole you opened…#6 on racquet with 16 mains.
5. Tune strings. Again #6, 7 & 8 should grow progressively higher in tone when strummed. It is probable that #7 will be too low. Fortunately you placed some reserve tension on string #8. You can now press down on the center of string #8 to manually shift some of that tension to string #7. Your tonal response should now be perfect. Also you will find when complete that all your mains will measure the same tension according to a String Meter.
CROSS STRINGS:
1. Start first two cross strings and tension at same tension as final mains. (+4 pounds over reference tension)
2. After installing the 2nd cross string, reduce tension 4 pounds and install the next several cross strings. Keep this tension through the 3rd cross from the bottom of the frame. (This will be the original reference tension)
3. After tensioning and clamping off the 3rd last cross, loop over and weave bottom cross.
4. For final cross string fill in second from bottom. Increase tension to +8 over reference. Pull tension, (this is another double pull), and clamp. Tie off on 3rd from bottom.
- Eiffel59Veterano
- Numero di messaggi : 72007
Età : 65
Località : Brescia/Parigi
Data d'iscrizione : 06.10.09
Profilo giocatore
Località:
Livello:
Racchetta: vedi firma
Re: tensionamento ultime orizzontali e verticali nel JayCee
A me mi sembra 'na gran str....
- fil27tUtente attivo
- Numero di messaggi : 446
Data d'iscrizione : 15.05.14
Profilo giocatore
Località:
Livello:
Racchetta: steel colander pro
Re: tensionamento ultime orizzontali e verticali nel JayCee
Eiffel59 ha scritto:Nella versione francese non c'è, sul sito di Stringway neppure.
A me mi sembra 'na gran str....
Pareva pure a me na gran ... !!! però sai quando trovo scritte le cose da qualcun altro penso sempre che ne capisca più di me
Eiffel hai il link della versione francese ?
- Eiffel59Veterano
- Numero di messaggi : 72007
Età : 65
Località : Brescia/Parigi
Data d'iscrizione : 06.10.09
Profilo giocatore
Località:
Livello:
Racchetta: vedi firma
Re: tensionamento ultime orizzontali e verticali nel JayCee
- fil27tUtente attivo
- Numero di messaggi : 446
Data d'iscrizione : 15.05.14
Profilo giocatore
Località:
Livello:
Racchetta: steel colander pro